NEWS
HEBEICHENGZEHUAGONGSHEBEICO.,LTD
How to replace Vibrating fluidized bed components
Vibrating fluidized bed components aging is one of the common failures of vibrating fluidized bed components. When Vibrating fluidized bed components appear aging and cracks or the installation height is lower than 105mm, they should be replaced. In addition, if the installation height is low or aging is cracked, all the Vibrating fluidized bed components should be replaced together, and the free height error of each group of Vibrating fluidized bed components is not more than 3mm.
The replacement method of Vibrating fluidized bed components is as follows.
Vibrating fluidized bed components must be replaced together, and only one method can be used for replacement. During the replacement, the center of gravity of the vibrating fluidized bed must be kept balanced when it is lifted into a pusher. For example, the lifting amount of the jack remains the same, and the replacement should be carried out at the minimum torque. The replacement of the rubber spring must be strictly inspected. The free height is the same height group based on H=130mm.
Note: When replacing the Vibrating fluidized bed components according to the push-top and hoist method, the height of the top (pull) on one side of the machine should ensure that the dryer body does not roll over.
CONTACT US
E-mail: sales@hbhgsb.cn
Tel: +86-311-83756555 / 83951911
Wechat: 18031837273
Fax: +86-311-85837070
Copyright 2020 Hebei Chengze Chemical Equipment Co., Ltd 冀ICP备18023413号-1 Powered by www.300.cn